Questo sito web utilizza i cookie. Utilizzando il nostro sito l'utente acconsente a tutti i cookie in conformità con la normativa vigente

Liners

In.Tra.Flex produces a wide range of plastic liners.

The plastic resin is determined mainly by two factors:
1) temperature range
2) friction coefficient (static and dynamic)

The most commonly used resins are HDPE, POM, PAs, PBT and PTFE. Anyhow, a new range of specialities is under development with the use of new technopolymer that may withstand higher temperature and show a lower friction coefficient to satisfy the most exigent requests.

Liner ϕ3.40

Inner diameter: 2.2mm
Outer diameter: 3.4mm
Resin: PTFE
CUT: 280-300°C
Static friction coefficient: 0.04
Dynamic friction coefficient: 0.04

Continue Reading

Liner ϕ5.00

Inner diameter: 3.7mm
Outer diameter: 5.0mm
Resin: PTFE
CUT: 280-300°C
Static friction coefficient: 0.04
Dynamic friction coefficient: 0.04

Continue Reading

Liner ϕ6.80

Inner diameter: 4.7mm
Outer diameter: 6.8mm
Resin: HDPE
CUT: 100-110°C
Static friction coefficient: 0.32
Dynamic friction coefficient: 0.28

Continue Reading

Liner ϕ7.80

Inner diameter: 6.3mm
Outer diameter: 7.8mm
Resin: HDPE
CUT: 100-110°C
Static friction coefficient: 0.32
Dynamic friction coefficient: 0.28

Continue Reading